RGB-F

F Connector Compression Seal Procedure
for RGB Cable

	1) Trim cable as shown using strip tool P/N GST-RGB. 2) Trim center conductor end at 45-degree angle.
	3) Mark cable as shown. 4) Slide compression sleeve onto cable.
	5) Slide optional color-coded “O” ring onto connector – will fit precisely in curve in body. 6) Push connector onto cable twisting connector clockwise and counterclockwise until connector end meets or passes mark on cable.
	7) Make sure F die head is in crimp tool P/N GET-RGB. Option: Spacer washer may be installed on die head if preferred. 8) Nest cable and connector into crimp tool. *Note: For right angle connectors, use F die head without spacer.
	9) Squeeze handle until compression sleeve is pushed into connector body. Die head may need some adjustment to push compression sleeve completely into connector body.
	10) Remove connector and cable from tool and give a pull (30 lbs) to assure proper termination.