 |
BNC
Connector Compression Seal Procedure for RG59 and 6 Type Cables |
|
|
1) Trim cable as shown using strip tool P/N GST-1. Trim center conductor end at 45-degree angle. |
 |
2)
Fold braid back.
* Note: For quad shield cable cut off first foil and fold back second braid. 3) Mark cable as shown. |
|
|
4) Push connector onto cable twisting connector clockwise and counter clockwise until connector end meets or passes mark on cable. |
 |
5)
Make
sure “BNC” die head is in crimp tool P/N GST-CS.
6) Nest cable and connector into crimp tool. * Note: For right angle and female connectors use no die head. |
 |
7) Squeeze handle. Crimp tool is ratcheted and will release when compression is completed. |
 |
8) Remove connector and cable from tool and give a pull (30 lbs) to assure proper termination. |
