 |
BNC
/ TNC 75 OHM Crimp / Crimp Cable Assembly Procedure |
|
|
1) Strip cable as shown. Cut center conductor at a 45 degree angle. |
 |
2a) Crimp
center contact onto center conductor. 2b) Slide crimp ferrule onto cable. 2c) Fold back braid. Note: When using 307-18-4 connector, slide dielectric support bushing onto cable. |
|
|
3) Hold cable tightly at braid area, push cable into back of connector until contact snaps into place. |
 |
4) Fold braid back over crimp body area of connector. |
 |
5) Push crimp ferrule up over braid and crimp. |
 |
6) Give connector a Pull to guarantee 30 lbs. cable retention. |
