 |
BNC
/ TNC 50 OHM Crimp / Crimp Cable Assembly Procedure |
|
|
1) Strip cable as shown with strip tool. Cut center conductor at a 45 degree angle. |
 |
2a) Crimp
center contact onto center conductor using crimp tool. 2b) Slide crimp ferrule onto cable. 2c) Fold back braid. Note: When using 305-18-4 connector, slide dielectric support bushing onto cable. |
|
|
3) Hold cable tightly at braid area, push cable into connector until contact snaps into place. |
 |
4) Fold braid back over crimp body area of connector. |
 |
5) Slide ferrule up over braid and crimp ferrule using crimp tool. |
 |
6) Give connector a Pull to guarantee 30 lbs. cable retention. |
